Hi,
I tested your program and the interrupt line stay in level 1 and no pulse. When I put my program the interrupt line stay in level 0 and no pulse too.
Could you send me the source code of this receiver that you changed? Maybe I can find any thing that help me, because the interrupt line of bee click change, like I told you above.
is it possible the pin out that you are using to this test too?
My transmiter routine (I am using the routine from libstock) and I don't have any problem. I am sending like your sample ( I am sending data from a counter - 0 to 0xFF) but when I receive data if I put delay I lost data, If I don't put delay the same data repeat several times. I check the interrupt line of the bee Click and no signal there, I have levl 0 only. I can see that you are using interrupt line to control data received, so if it is level 0 the data will repeat any way.
Please help.
Thanks!
I didn't find the right solution from the Internet.
References
https://forum.mikroe.com/viewtopic.php?f=12&t=688912d animation